WIP is crafter lingo for Works in Progress, otherwise known as UFOs, or UnFinished Objects. 🙂
Today’s WIP is none other than Wascana Creek!
I am technically finished, as the photo above shows. What I need to do is sew a hanging sleeve on the back to insert a dowel to hang the wall hanging from.
Part of my dallying has been around deciding which hanging system to use – the hook and loop tape or the hanging sleeve. Both have their merits. It’s a question of whether the wall hanging is heavy enough it would bend the dowel that goes through the hanging sleeve system. I think, over time, it would bend a 1/4″ dowel, my standard dowel size. I am going to try a wider diameter dowel.
The hook and loop system is failproof. The loop side is attached to the back of the wall hanging. While the hook side is attached to a piece of oak trim that has been shellacked. I put holes at either end of the oak board and screw it to the wall through those holes. Then just pop the wall hanging up on the board. Very sturdy. This system can handle a lot of weight. I have come to the realization that my larger rugs are definitely on the heavy side.
Whenever I speak to patrons about the two systems they invariably prefer the hanging sleeve system because they view it as not damaging the wall as much as the hook and loop system, and as being easier to install. I can’t blame them. My Hubby feels the same way. But if you want to prevent sag in a large heavy hooked wall hanging, you really need to use the hook and loop system. Plus have some reinforcing done on the back of the wall hanging.
Next up? My unfinished project for the remainder of the week is a Hardanger bell pull I started many years ago and never finished. It has a very small section of stitches to fill in to complete. I am hoping to complete it in short order.